Brocade FastIron Ethernet Switch Stacking Configuration Gu Bedienungsanleitung PDF herunterladen (Seite 20)

on FCX-S or FCXS-F devices to the ports on the front panel. For more information about reconfiguring

default stacking ports, refer to Configuring default ports on FCX devices on page 36.

FIGURE 4 Mixed linear stack of FCX-E devices and FCX-S devices

ICX 6610 stacking for different topologies

Earlier generations of Brocade switches did not have ports exclusively dedicated to stacking. ICX 6610

devices include 4 ports on the back panel that are used entirely for this purpose. Note that these ports

cannot be used as data ports, even when stacking is not enabled.

There are the two 40-Gbps ports and two 4 x 10-Gbps ports arranged in two rows. By default, these

ports form stacked trunks. The figure below shows one stacked trunk on the top row between 1/2/1

and 1/2/2 and the second stacked trunk on the bottom row between 1/2/6 and 1/2/7.

FIGURE 5 ICX 6610 device back panel

To properly connect stacked trunk ports between devices, you must connect corresponding trucks

from one device to another. For example, the following figures show correctly connected ports. The

two stacked trunks can form either linear or ring topologies.

ICX 6610 stacking for different topologies

18 FastIron Ethernet Switch Stacking Configuration Guide

53-1003090-02

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 159 160

Keine Kommentare

Brocade FastIron Ethernet Switch Stacking Configuration Gu Bedienungsanleitung Seite 20