Brocade Multi-Service IronWare Switching Configuration Gui Bedienungsanleitung PDF herunterladen (Seite 360)

100

101

330 Multi-Service IronWare Switching Configuration Guide

53-1003036-02

IEEE 802.1D Spanning Tree Protocol (STP)

Bridge MaxAge sec The number of seconds this bridge waits for a hello message from the root

bridge before deciding the root has become unavailable and performing a

reconvergence.

Bridge Hello sec The interval between each configuration BPDU sent by the bridge.

Bridge FwdDly sec The number of seconds this bridge waits following a topology change and

consequent reconvergence.

Hold Time sec The minimum number of seconds that must elapse between transmissions of

consecutive Configuration BPDUs on a port.

Last Topology Change sec The number of seconds since the last time a topology change occurred.

Topology Change cnt The number of times the topology has changed since this device was reloaded.

Root Bridge Parameters

Root Identifier The ID assigned by STP to the root bridge for this spanning tree in hexadecimal.

Root Cost The cumulative cost from this bridge to the root bridge. If this device is the root

bridge, then the root cost is 0.

DesignatedBridge Identifier The designated bridge to which the root port is connected. The designated

bridge is the device that connects the network segment on the port to the root

bridge.

Root Port The port on this device that connects to the root bridge. If this device is the root

bridge, then the value is “Root” instead of a port number.

Max Age sec The number of seconds this root bridge waits for a hello message from the

bridges before deciding a bridges has become unavailable and performing a

reconvergence.

Hello sec The interval between each configuration BPDU sent by the root bridge.

FwdDly sec The number of seconds this root bridge waits following a topology change and

consequent reconvergence.

Port STP Parameters

Port Num The port number.

Priority The port’s STP priority.

NOTE: If you configure this value, specify it in decimal format. Refer to

“Changing STP port parameters”.

Path Cost The port’s STP path cost.

TABLE 53 CLI display of STP information (Continued)

This field... Displays...

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 983 984

Kommentare zu diesen Handbüchern

Keine Kommentare

Brocade Multi-Service IronWare Switching Configuration Gui Bedienungsanleitung Seite 360

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerzubehör Brocade Multi-Service IronWare Switching Configuration Gui