Brocade Multi-Service IronWare Switching Configuration Gui Bedienungsanleitung PDF herunterladen (Seite 973)

100

101

Multi-Service IronWare Switching Configuration Guide 943

53-1003036-02

show mpls lsp

Tunnel interface: The status of the tunnel interface can be one of the following:

• UP – The tunnel interface is functioning properly.

• DOWN – The tunnel interface is not functioning and is down.

outbound interface: The outbound interface taken by the active path of the LSP. When the

egress interface is a VE-enabled interface, the VE interface ID specified by

the vid variable is displayed here in the Outbound interface field.

Tunnel index: The tunnel index for the active path of the LSP.

Tunnel instance: The MPLS tunnel interface port ID.

outbound label: The outbound label used by the active path of the LSP.

Path calculated using

constraint-based routing:

Whether the explicit path used by the active path was calculated using the

constraint-based routing.

Path calculated using interface

constraint:

Directs the router to include the interface address as a constraint when it

determines the shortest path.

Explicit path hop count: The number of explicit hops configured for the LSP, the addresses of the

hops, and whether the hops are strict (S) or loose (L).

Recorded routes: The addresses recorded by the RECORD_ROUTE object during RSVP

signalling.

BFD session status: Describes the status of the BFD session on this LSP as either UP or DOWN.

If a BFD session for the LSP is enabled and the BFD session is DOWN, one

of the following:

reasons for failure will be displayed:

• BFD disabled globally

• LSP down

• Max session exceeded

• Max LP session exceeded

• Peer session down

• Wait for peer

Config param: Describes how the BFD configuration values were derived:

• global – Displayed if the configuration values were derived from the

router’s global LSP BFD configuration.

• local – Displayed if the configuration values were derived from a BFD

configuration specific to this LSP.

min-tx: The min-tx value in milliseconds that is configured for this LSP.

min-rx: The min-rx value in milliseconds that is configured for this LSP.

multiplier: The multiplier value that is configured for this LSP.

Negotiated tx-interval: The tx-interval value in milliseconds that has been negotiated between this

router and its peer for this LSP.

rx-interval: The rx-interval value in milliseconds that has been negotiated between this

router and its peer for this LSP.

multiplier: The multiplier value in milliseconds that has been negotiated between this

router and its peer for this LSP.

Local discriminator: Value of the ‘local discriminator’ field in the BFD Control Message as used

by the local router in the last message sent.

remote discriminator: Value of the local discriminator field in the BFD Control Message as

received in the last message sent by the remote peer.

Output field Description

1 2 ... 968 969 970 971 972 973 974 975 976 977 978 ... 983 984

Kommentare zu diesen Handbüchern

Keine Kommentare

Brocade Multi-Service IronWare Switching Configuration Gui Bedienungsanleitung Seite 973

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerzubehör Brocade Multi-Service IronWare Switching Configuration Gui